-
Infrared Motion Detection Sensor
Contact TypeThe Infrared Motion Detection sensor can be used with all Sensaphone models to monitor the movement of warm bodies in a specific area. It will cause an alarm if motion is detected. Its range of detection covers approximately forty feet of area. Multiple sensors can be wired in series to a single outputMagnetic Reed Door and Window Switch
Contact TypeThe magnetic reed switch may be used with all Sensaphone Models to detect any unauthorized entry or intrusion. They are usually installed on doors or windows to detect their opening and closing. Several magnetic reed switches may be wired in series.Accessory Wire
50 Foot Coil50ft. of 22-gauge shielded wire for connecting sensors to your Sensaphone.Spot Water Detection Sensor
Contact TypeThe water detection sensor can be used with all Sensaphone models to detect the presence of water on a horizontal surface. Independently powered by internal lithium batteries. The batteries should last for approximately 3-5 years.Temp Alert Temperature Switch
Contact TypeThe Temp Alert Temperature Switch can be used with all Sensaphone models to monitor air temperature from -30° to 130°F (-34° to 54°C). Simply determine the acceptable temperature limits for your application by adjusting the temperature limit arms. When the temperature exceeds the setting, the sensor triggers an alarm.Humidistat Humidity Switch
Contact TypeThe Humidistat Humidity Switch can be used with all Sensaphone models to detect a high or low humidity level. The device will cause your Sensaphone to activate an alarm when the humidity level reaches a set threshold.24VDC Power Supply
Accessory for 4-20mA SensorsA 24V power supply for use with most 4-20mA sensors. It is required when connecting the humidity transmitter to any Sensaphone that does NOT provide external 24V DC power. The Sensaphone SCADA 3000 and Express II are the only units that supply their own power.24VDC Power Supply w/ Battery Backup
Accessory for 4-20mA SensorsA 24V power supply for use with most 4-20mA sensors. It is required when connecting the humidity transmitter to any Sensaphone that does NOT provide external 24V DC power. The Sensaphone SCADA 3000 and Express II are the only units that supply their own power.
